Earthquake induced pressures on a rigid wall structure

Authors

  • J. H. Wood Ministry of Works and Development, Wellington, New Zealand

DOI:

https://doi.org/10.5459/bnzsee.8.3.175-186

Abstract

This paper describes the application of linear elastic theory to estimate the earthquake-induced soil pressures on a wall forming part of the structure of a power station founded on rock.

Analyses showed that the Mononobe-Okabe assumptions would not be applicable for this relatively rigid wall structure and it was found that elasticity theory gave greater forces and moments than would be obtained by using the Mononobe-Okabe method. The extent to which deformations of the structure and its foundations influence the wall pressures was investigated. It was found that even for this relatively rigid structure and foundation, the displacements resulting from the inertia of the wall structure can produce a significant increase in the total forces acting on the wall.

References

Housner, G. W., Response Spectra Prepared for, "Nuclear Reactors and Earthquakes," Report No. TID 7024, U.S. Atomic Energy Commission, August, 1963.

Housner, G. W. and Jennings, P. C., "Generation of Artificial Earthquakes", Journal of the Engineering Mechanics Division, ASCE, Vol. 90, No. EMI, January, 1964. DOI: https://doi.org/10.1061/JMCEA3.0000448

Mononobe, N. and Matsuo, M., "On the Determination of Earth Pressures During Earthquakes," Proceedings, World Engineering Congress, Vol. 9, 1929.

Seed, H. B. and Whitman, R. V., "Design of Earth Retaining Structures for Dynamic Loads," ASCE, Specialty Conference, Lateral Stresses in the Ground and the Design of Earth-Retaining Structures, Cornell University, 1970.

Wood, J. H., "Earthquake-Induced Soil Pressures on Structures", Report No. EERL 73-05, Earthquake Engineering Research Laboratory, California Institute of Technology, Pasadena, 1973.

Downloads

Published

30-09-1975

How to Cite

Wood, J. H. (1975). Earthquake induced pressures on a rigid wall structure. Bulletin of the New Zealand Society for Earthquake Engineering, 8(3), 175–186. https://doi.org/10.5459/bnzsee.8.3.175-186

Issue

Section

Articles

Categories