Computational modelling of a four storey post-tensioned concrete building subjected to shake table testing
Prior research into low-damage wall systems has predominately focused on the walls behaviour in isolation from other building components. Although the response of these isolated walls has been shown to perform well when subjected to both cyclic and dynamic loading, uncertainty exists when considering the effect of interactions between walls and other structural and non-structural components on the seismic response and performance of entire buildings. To help address this uncertainty a computational model was developed to simulate the response of a full-scale four-storey building with post-tensioned precast concrete walls that was subjected to tri-axial earthquake demands on the E-Defence shake table. The model accurately captured the buildings measured response by incorporating the in-plane and out-of-plane non-linear behaviour of both the wall and floor elements. The model was able to simulate the deformation demands imposed on the floor due to compatibility with the post-tensioned walls, closely matching the behaviour and damage observed during the test. Dynamic loading and wall-to-floor interaction were shown to significantly increase the over-strength actions that developed when compared to the wall system considered in isolation.
Marquis F, Kim JJ, Elwood KJ and Chang SE (2017). “Understanding post-earthquake decisions on multi-storey concrete buildings in Christchurch New Zealand”. Bulletin of Earthquake Engineering, 15(2): 731-758. DOI: https://doi.org/10.1007/s10518-015-9772-8
Priestley MJN, Sritharan S, Conley JR and Pampanin S (1999). “Preliminary results and conclusions from the PRESSS five-story precast concrete test building”. PCI Journal, 44(6): 42-67. DOI: https://doi.org/10.15554/pcij.11011999.42.67
Perez FJ, Pessiki S and Sause R (2013). “Experimental lateral load response of unbonded post-tensioned precast concrete walls”. ACI Structural Journal, 110(6): 1045-1055.
Smith BJ, Kurama YC and McGinnis MJ (2011). “Design and Measured Behavior of a Hybrid Precast Concrete Wall Specimen for Seismic Regions”. Journal of Structural Engineering, 137(10): 1052-1062. DOI: https://doi.org/10.1061/(ASCE)ST.1943-541X.0000327
Sritharan S, Aaleti S, Henry RS, Liu KY and Tsai KC (2015). “Precast concrete wall with end columns (PreWEC) for earthquake resistant design”. Earthquake Engineering and Structural Dynamics, 44(12): 2075-2092. DOI: https://doi.org/10.1002/eqe.2576
Henry RS, Brooke NJ, Sritharan S and Ingham JM (2012). “Defining concrete compressive strain in unbonded post-tensioned walls”. ACI Structural Journal, 109(1): 101-112.
Twigden KM (2016). “Dynamic Response of Unbonded Post-tensioned Concrete Walls for Seismic Resilient Structures”. PhD Thesis, University of Auckland, Auckland, New Zealand.
Marriott D, Pampanin S, Bull DK and Palermo A (2008). “Dynamic testing of precast, post-tensioned rocking wall systems with alternative dissipating solutions”. Bulletin of the New Zealand Society for Earthquake Engineering, 41(2): 90-103. DOI: https://doi.org/10.5459/bnzsee.41.2.90-103
Holden T, Restrepo J and Mander JB (2003). “Seismic performance of precast reinforced and prestressed concrete walls”. Journal of Structural Engineering, 129(3): 286-296. DOI: https://doi.org/10.1061/(ASCE)0733-9445(2003)129:3(286)
Henry RS, Sritharan S and Ingham JM (2016) “Finite element analysis of the PreWEC self-centering concrete wall system”. Engineering Structures, 115: 28-41. DOI: https://doi.org/10.1016/j.engstruct.2016.02.029
Belleri A, Schoettler MJ, Restrepo JI and Fleischman RB (2014). “Dynamic behavior of rocking and hybrid cantilever walls in a precast concrete building”. ACI Structural Journal, 111(3): 661-671. DOI: https://doi.org/10.14359/51686778
Nagae T, Tahara K, Fukuyama K, Matsumori T, Shiohara H, Kabeyasawa T, Kono S, Nishiyama M and Nishiyama I (2012). “Seismic Performance Assessment and Improvement of Prestressed Concrete Buildings Based on E-Defence Shaking Table Test”. Journal of Structural and Construction Engineering, Architectural Institute of Japan, 77(671): 75-84. DOI: https://doi.org/10.3130/aijs.77.75
Tanyeri AC (2014). “Seismic Performance and Modeling of Reinforced Concrete and Post-Tensioned Precast Concrete Shear Walls”. PhD Thesis, University of California, Berkeley, California.
Gavridou S, Wallace JW, Nagae T, Matsumori T, Tahara K and Fukuyama K (2017). “Shake-table test of a full-scale 4-story precast concrete building. II: Analytical studies”. ASCE Journal of Structural Engineering, 143(6).
Nagae T, Tahara K, Matsumori T, Shiohara H, Kabeyasawa T, Kono S, Nishiyama I, Wallace JW, Ghannoum W, Moehle J, Sause R, Keller W and Tuna Z (2011). “Design and Instrumentation of the 2010 E-Defence Four-Story Reinforced Concrete and Post-Tensioned Concrete Buildings”. PEER Report, (PEER-2011/104).
Gavridou S, Wallace JW, Nagae T, Matsumori T, Tahara K and Fukuyama K (2017). “Shake-table test of a full-scale 4-story precast concrete building. I: Overview and experimental results”. ASCE Journal of Structural Engineering, 143(6).
Standards New Zealand (2004). “NZS1770.5: 2004 Structural Design Actions”. Standards New Zealand, Wellington.
“Four-Storey Reinforced Concrete and Post-Tensioned E-Defence Building Tests”. Available from: http://nees.org/warehouse/experiment/4841/project/1005.
SAP2000 18.1.1 (2016). Computers and Structures, Berkley, California.
Watkins J (2017). “Seismic Response of Buildings that Utilise Unbonded Post-Tensioned Concrete Walls”. PhD Thesis, University of Auckland, Auckland.
Bentz E and Collins MP (2001). Response 2000. University of Toronto, Canada.
Standards New Zealand (2006). “NZS3101: 2006 Concrete Structures Standard”. Standards New Zealand, Wellington.
Arteta CA (2015). “Seismic Response Assessment of Thin Boundary Elements of Special Concrete Shear Walls”. PhD Thesis, University of California, Berkeley, USA.
Welt TS (2015). “Detailing for Compression in Reinforced Concrete Wall Boundary Elements: Experiments Simulations and Design Recommendations”. PhD Thesis, University of Illinois at Urbana-Champaign, Illinois, USA.
Mander JB, Priestley MJN and Park R (1988). “Theoretical Stress-Strain Model for Confined Concrete”. Journal of Structural Engineering, 114(8): 1804-1826. DOI: https://doi.org/10.1061/(ASCE)0733-9445(1988)114:8(1804)
Moehle J (2014). “Seismic Design of Reinforced Concrete Buildings”. McGraw-Hill, New York.
Takeda T, Sozen MA and Nielsen NN (1970). “Reinforced concrete response to simulated earthquakes”. Journal of Structural Engineering, 96(12): 2257-2273.
Holzer S, Melosh R, Barker R and Somers A (1975). “SINGER: A Computer Code for General Analysis of Two-Dimensional Reinforced Concrete Structures". National Technical Information Service, U.S. Department of Commerce, Virginia.
Devalapura RK and Tadros MK (1992). “Stress-strain modeling of 270 ksi low-relaxation prestressing strands”. PCI Journal, 37(2): 100-105. DOI: https://doi.org/10.15554/pcij.03011992.100.106
Darwin D and Pecknold DAW (1974). “Inelastic model for cyclic biaxial loading of reinforced concrete”. University of Illinois, Illinois.
Vecchio FJ and Collins MP (1986). “The Modified Compressed-Field Theory for reinforced concrete elements subject to shear”. ACI Journal, 83-22: 219-231.
He XG and Kwan AKH (2001). “Modeling dowel action of reinforcement bars for finite element analysis of concrete structures”. Computers and Structures, 79: 595-604.
Pennucci D, Calvi GM and Sullivan TJ (2009). “Displacement-based design of precast walls with additional dampers”. Journal of Earthquake Engineering, 13(1): 40-65. DOI: https://doi.org/10.1080/13632460902813265
Nazari M (2016). “Seismic performance of unbonded post-tensioned precast wall systems subjected to shake table testing”. PhD Thesis, Iowa State University, Iowa.
Nagae T, Ghannoum W, Kwon J, Tahara K, Fukuyama K, Matsumori T, Shiohara H, Kabeyasawa T, Kono S, Nishiyama I, Sause R, Wallace JW and Moehle JP (2015). “Design implications of large-scale shake-table test on four-story reinforced concrete building”. ACI Structural Journal, 112(2): 135-146. DOI: https://doi.org/10.14359/51687421
Copyright (c) 2017 Jonathan Watkins, Sri Sritharan, Takuya Nagae, Richard S. Henry
This work is licensed under a Creative Commons Attribution 4.0 International License.