Modal identification of a bridge-abutment system using forced vibration testing

Authors

DOI:

https://doi.org/10.5459/bnzsee.45.4.161-170

Abstract

During the 2010 Mw7.1 Darfield earthquake, the single span Davis Road Bridge located 5 km southeast of Lincoln, New Zealand, sustained significant lateral spreading damage to the western approach. While lateral spreading resulted in up to 450 mm of approach settlement and evidence of damage to the pile foundations, the bridge superstructure sustained no significant damage. Prior to reinstating traffic, the bridge was used for full scale dynamic testing to characterise the influence of different substructure components on the lateral dynamic behaviour of the bridge superstructure.

The bridge was characterised using an eccentric mass shaker and an array of accelerometers to perform lateral forced vibration testing in both the transverse and longitudinal directions. Modal properties were extracted from these tests using multiple system identification algorithms. The experimental testing and system identification methodology are described here. Forced vibration testing was able to detect one mode in each principal direction of the bridge, with the fundamental modes for the transverse and longitudinal direction occurring at a period of 0.118 s and 0.092 s respectively. The torsional response found during the transverse direction shaking was most likely due to the effect of gap opening around the piles on the western abutment, while the longitudinal response was dominated by the approach soil.

References

El-Gamal, M. and R.V. Siddharthan, (1998). "Stiffnesses of Abutments on Piles in Seismic Bridge Analyses". Soils and Foundations, 38 (1): 77-87. DOI: https://doi.org/10.3208/sandf.38.77

Kotsoglou, A. and S. Pantazopoulou, (2009). "Assessment and Modeling of Embankment Participation in the Seismic Response of Integral Abutment Bridges". Bulletin of Earthquake Engineering, 7 (2): 343-361. DOI: https://doi.org/10.1007/s10518-009-9103-z

Zhang, J. and N. Makris, (2002). "Seismic Response Analysis of Highway Overcrossing Including Soil-Structure Interaction". Earthquake Engineering and Structural Dynamics, 31 (11): 1967-1991. DOI: https://doi.org/10.1002/eqe.197

Stewart, J.P., E. Taciroglu, J.W. Wallace, E.R. Albergh, A. Lemnitzer, C. Rha, and P.K. Tehrani, (2007). "Full Scale Cyclic Testing of Foundation Support Systems for Highway Bridges. Part II: Abutment Backwalls". (UCLA-SGEL Report 2007/02).

Aviram, A., K.R. Mackie, and B. Stojadinovic, (2008). "Effect of Abutment Modeling on the Seismic Response of Bridge Structures". Earthquake Engineering and Engineering Vibration, 7 (4): 395-402. DOI: https://doi.org/10.1007/s11803-008-1008-3

Goel, R.K. and A.K. Chopra, (1997). "Evaluation of Bridge Abutment Capacity and Stiffness During Earthquakes", Earthquake Spectra. 13 (1): 1-23. DOI: https://doi.org/10.1193/1.1585929

Anastasopoulos, I., T. Georgarakos, V. Georgiannou, V. Drosos and R. Kourkoulis, (2010). "Seismic Performance of Bar-Mat Reinforced-Soil Retaining Wall: Shaking Table Testing Versus Numerical Analysis with Modified Kinematic Hardening Constitutive Model". Soil Dynamics and Earthquake Engineering, 30 (10): 1089-1105. DOI: https://doi.org/10.1016/j.soildyn.2010.04.020

Johnson, N., R.T. Ranf, M.S. Saiidi, D. Sanders and M. Eberhard, (2008). "Seismic Testing of a Two-Span Reinforced Concrete Bridge". Journal of Bridge Engineering, 13 (2): 173-182. DOI: https://doi.org/10.1061/(ASCE)1084-0702(2008)13:2(173)

Moss, P.J., A.J. Carr and G.C. Pardoen, (1982). "The Vibrational Behaviour of Three Composite Beam-Slab Bridges". Engineering Structures, 4 (4): 277-288. DOI: https://doi.org/10.1016/0141-0296(82)90034-7

Samman, M.M. and M. Biswas, (1994). "Vibration Testing for Nondestructive Evaluation of Bridges. I: Theory". Journal of Structural Engineering, 120 (1): 269-289. DOI: https://doi.org/10.1061/(ASCE)0733-9445(1994)120:1(269)

Bolton, R., C. Sikorsky, S. Park, S. Choi and N. Stubbs, (2005). "Modal Property Changes of a Seismically Damaged Concrete Bridge", Journal of Bridge Engineering. 10 (4): 415-428. DOI: https://doi.org/10.1061/(ASCE)1084-0702(2005)10:4(415)

Halling, M.W., I. Muhammad, and K.C. Womack, (2001). "Dynamic Field Testing for Condition Assessment of Bridge Bents". Journal of Structural Engineering, 127 (2): 161-167. DOI: https://doi.org/10.1061/(ASCE)0733-9445(2001)127:2(161)

Elgamal, A.W., S. Alampalli and P. Van Laak, (1996). "Forced Vibration of Full-Scale Wall-Backfill System". Journal of Geotechnical and Geoenvironmental Engineering, 122 (10): 849-858. DOI: https://doi.org/10.1061/(ASCE)0733-9410(1996)122:10(849)

Wilson, P. and A. Elgamal, (2009). "Full-Scale Shake Table Investigation of Bridge Abutment Lateral Earth Pressure". Bulletin of the New Zealand Society for Earthquake Engineering, 42 (1): 39-46. DOI: https://doi.org/10.5459/bnzsee.42.1.39-46

Crouse, C.B., B. Hushmand and G.R. Martin, (1987). "Dynamic Soil-Structure Interaction of a Single-Span Bridge". Earthquake Engineering & Structural Dynamics, 15 (6): 711-729. DOI: https://doi.org/10.1002/eqe.4290150605

Site Investigation Ltd., (2004). "Piezocone Penetrometer Test (CPTU) Report: Davis Road".

Palermo, A., M.L. Heux, M. Bruneau, M. Anagnostopoulou, L. Wotherspoon and L. Hogan, (2010). "Preliminary Findings on Performance of Bridges in the 2010 Darfield Earthquake". Bulletin of the New Zealand Society for Earthquake Engineering, 43 (4): 412-420. DOI: https://doi.org/10.5459/bnzsee.43.4.412-420

Yashinsky, M. and M.J. Karshenas, (2003). Fundamentals of Seismic Protection for Bridges. Earthquake Engineering Research Institute, Oakland, CA.

Youd, T.L., I.M. Idriss, R.D. Andrus, I. Arango, G. Castro, J.T. Christian, R. Dobry, W.D. Liam Finn, Harder L.F, Jr., M.E. Hynes, K. Ishihara, J.P. Koester, S.S.C. Liao, W.F. Marcuson III, G.R. Martin, J.K. Mitchell, Y. Moriwaki, M.S. Power, P.K. Robertson, R.B. Seed and K.H. Stokoe II, (2001). "Liquefaction Resistance of Soils: Summary Report from the 1996 NCEER and 1998 NCEER/NSF Workshops on Evaluation of Liquefaction Resistance of Soils". Journal of Geotechnical and Geoenvironmental Engineering, 127 (10): 817-833. DOI: https://doi.org/10.1061/(ASCE)1090-0241(2001)127:10(817)

GNS Science, (2012). Geonet. Accessed: September 20, 2012, http://www.geonet.org.nz.

Wotherspoon, L., A. Bradshaw, R. Green, C. Wood, A. Palermo, M. Cubrinovski and B. Bradley, (2011). "Performance of Bridges During the 2010 Darfield and 2011 Christchurch Earthquakes". Seismological Research Letters, 82 (6): 950-964. DOI: https://doi.org/10.1785/gssrl.82.6.950

Beskhyroun, S., (2011). "Graphical Interface Toolbox for Modal Analysis". in Ninth Pacific Conference on Earthquake Engineering: Auckland, New Zealand.

Brincker, R., L. Zhang and P. Andersen, (2001). "Modal Identification of Output-Only Systems Using Frequency Domain Decomposition". Smart Materials and Structures, 10 (3): 441-445. DOI: https://doi.org/10.1088/0964-1726/10/3/303

Jacobsen, N.J., P. Andersen, and R. Brincker, (2007). "Using EFDD as a Robust Technique to Deterministic Excitation in Operational Modal Analysis". In The 2nd International Operational Modal Analysis Conference (IOMAC): Copenhagen, Denmark.

Katayama, T., (2005). Subspace Methods for System Identification. Springer, London. DOI: https://doi.org/10.1007/1-84628-158-X

Allemang, R.J., (2003)."The Modal Assurance Criterion - Twenty Years of Use and Abuse". Sound and Vibration, 37 (8): 14-21.

Downloads

Published

31-12-2012

How to Cite

Hogan, L., Wotherspoon, L., Beskhyroun, S., & Ingham, J. (2012). Modal identification of a bridge-abutment system using forced vibration testing. Bulletin of the New Zealand Society for Earthquake Engineering, 45(4), 161–170. https://doi.org/10.5459/bnzsee.45.4.161-170

Issue

Section

Articles

Categories